Owner manual

SETUP AND OPERATING PROCEDURES
24
Ag-Bag International, Ltd.
MB7010 HyPac November 2003
Section 4
BAGGING PROCEDURE
THINK SAFETY AT ALL TIMES
It is important that you set up a
communications system be-
tween the operator of the Ag-
Bagger
®
and all other persons
involved in the bagging process.
By using a combination of the
Communications lights located
on the cab and engine cowling
and the horn. These communi-
cations devices are controlled
by buttons located on the Arm
Rest Console. Once this sys-
tem is setup, to eliminate con-
fusion, it should not be
changed.
Before proceeding it is important
that all personal that will be in-
volved in the bagging operation
read and understand the Safety
section of this manual.
1. Make sure that no one is al-
lowed on the Ag-Bagger
®
when
it is in operation. If you need to
make any adjustments stop the
Ag-Bagger
®
and then proceed.
Make sure the operator is aware
of the location of any worker in
the area.
2. Prior to starting the Ag-Bag-
ger
®
make a trip around the en-
tire machine and make sure that
all shields are in place and se-
cured.
Engine EndCab End