Owner manual

TROUBLESHOOTING
3
Ag-Bag International, Ltd.
MB7010 HyPac November 2003
Section 6
PROBLEM
CAUSE
CORRECTION
ANCHORS WILL NOT RETRACT 1. Anchor float switch on.
1. Turn anchor float off.
2. Anchors out to far. To much
pressure.
2. Pull machine ahead and re-
tract anchors.
FEED TABLE BELT NOT MOVING
1. Feed Table Belt to Loose
1. Tighten both Feed Table belt
adjustors to get belt moving and
then follow up with tracking ad-
justment.
FEED TABLE BELT NOT MOVING -
BELT IS TIGHT
1. Feed is to wet and heavy and
Feed Table motor is going over
relief.
1. Back off wheel brakes and
power in the PAC anchor to help
move the feed to the rotor.
FEED TABLE BELL NOT MOVING
FORWARD BUT WILL MOVE IN RE-
VERSE
1. High speed RPM is out of ad-
justment.
1. Adjust high speed to operate
Automatic Feed Table Control
(AFC). The high speed RPM
needs to be above 2200 or be-
low 1100.
FEED TABLE BELT IS MOVING FOR-
WARD BUT WILL NOT MOVE FEED
TO ROTOR.
1. Feed to wet or to dry to move
and is slipping on belt.
1. Back off wheel brakes and
power in the PAC anchor to help
move the feed to the rotor