Operator`s manual

Hiniker 8605
PFadvantage
Application Rate Mode
Ag Leader Technology
September 2003
2-88
3. Press EXIT key to return to screen with ADVANCED SETTINGS
key on bottom. Press the ADVANCED SETTINGS key.
Target Rate Outside Field: This only pertains to using a target
file.
Set to ZERO if want rate outside field to be zero.
Set to USE LAST if want rate to be the last rate used at
the time the vehicle is detected outside the field. This
is useful when experiencing problems with the vehicle
being falsely detected outside of the field during the
outside pass.
Set to TGT DEFAULT if want rate outside field to be the
default rate stored in the target rate file.
Controller Time Delay: Set to 3 seconds. This is delay of
controller to change application equipment to new rate + 2
seconds.
Actual Rate Units: Ignore this setting.
Log Actual Rate: Set to YES to log actual rate to card. Set to
NO, otherwise.
4. Exit back to main screen.
a)Press FIELD key twice.
b)Select appropriate field and press VIEW CONFIG key.
c)Select appropriate product/controller configuration and press
ACTIVE ON/OFF key to check it as active.(All other configs
must be unchecked first).
d)If you will be using a target file, press EDIT TGT FILE key,
otherwise press EXIT key and skip to step f.
e)Select target file. Press VIEW INFO key to ensure it is the
correct one. After exiting view info screen, press ACCEPT
key. Press EXIT key.
f)Press ACCEPT key to accept field.