Operator`s manual

PFadvantage
Site Verification
Ag Leader Technology
September 2003
4-39
Introduction
You can use the PFadvantage with a GPS receiver in a tractor or other
vehicle to record data for making maps of where:
• You plant different seed varieties or seed populations
• You apply different herbicides, pesticides, or fertilizers, or use different
application rates
• tile lines, known problem areas, or other fixed field features
• To perform grid and field boundary function for soil sampling, refer to
Operation Section for instruction.
Requirements
• Memory card
• Cables to install the monitor in a tractor or other vehicle
• Monitor-mounting bracket
NOTE:
Cables (to connect to a ground speed sensor or implement switch) and
monitor-mounting bracket can be ordered from your Ag Leader
Technology dealer.
Site Verification
Operating Mode
To perform site verification, you must have the monitor set on the “Site
Verification” operating mode. To view and change the operating mode you
must press the SETUP key and then the CONSOLE key. Instructions for
changing the operating mode are in the setup section under console setup.
Logging to the
Card
In the “Site Verification” operating mode the following starts or stops
logging to the card:
• If the area count switch is in the up position and the monitor displays
“Area On” the monitor will
log to the card (if you are using an
implement switch, it automatically starts and stops logging to the card
when the implement is raised and lowered on the ends).
• If the area count switch is in the down position and the monitor
displays “Area Off” then the monitor will not
log to the card.