Operator`s manual

PFadvantage
Swath Setup
Ag Leader Technology
Site Verification Mode
September 2003
2-41
Introduction
The swath setup screen is used to set the permanent, full swath of your
application equipment. Do not adjust the swath setting on this screen when
you encounter a partial swath in the field. Refer to the Swath Setting
instructions in Operation Section and select swath as a display item and set
a partial swath.
NOTE: If you do not want to count area, you do not need to set the
swath.
Swath Setup
Screen
Refer to the swath setup instructions for harvest mode for instructions on
viewing the swath setup screen and setting the swath.
Recommendations
To enter a swath setting, you must enter a number of rows setting and a row
spacing setting for the product you are applying.
Application equipment that uses row units
If your application equipment is applying the product with row units, then
enter the number of rows and row spacing of the application equipment.
Application equipment that uses boom sections
If your application equipment is applying the product using boom sections
enter the width of the boom section in inches for the row spacing setting.
Enter the total number of booms for the number of rows setting. If your
boom sections are not all the same width, enter twelve inches for the row
spacing setting and a number rows setting that makes the total swath equal
the full swath of the application equipment.
Application equipment that uses a spreader mechanism
If your application equipment is applying the product using a spreading
mechanism enter twelve inches for the row spacing setting and a number
rows setting that makes the total swath equal the full swath of the
application equipment.
* * *