Operator`s manual

PFadvantage
Vehicle Setup
Ag Leader Technology
Site Verification Mode
September 2003
2-43
Press the UP or DOWN ARROW key to scroll down to highlight a setting
and press the EDIT key to change a setting, then press ACCEPT key. After
making changes, press EXIT key.
Choose the vehicle you want to use and press ACCEPT VEHICLE key.
Area count stop
beeps
This setting is for the number of times the monitor beeps when the monitor
stops counting area at the end of a pass.
Primary and
Secondary speed
sensor
The monitor has four different primary speed settings. They are listed
below.
Ground Speed Sensor Primary Speed Sensor
Speed sensor on transmission WHEEL
Speed sensor on tracks TRACK
Radar gun RADAR
GPS receiver GPS
***