Operator`s manual

PFadvantage
DICKEY-john Land Manager
Ag Leader Technology
Application Rate Mode
September 2003
2-57
Product: Press EDIT key. You can select an existing
product and press ACCEPT key or create a new product
by pressing CREATE NEW key. Press EDIT NAME key
and enter name of product. Use Left or Right Arrow keys
to select a character. Use Up or Down Arrow key to
change the character. To erase a character in the name,
highlight that character and use UP or DOWN ARROW
key to scroll to the blank space between "9" and "A". Set
every character and press ACCEPT key twice.
Units: Set to GALLONS if applying liquid. Set to
POUNDS if applying granular product. Set to Units/Acre
of application.
Ground Speed Sensor: Set primary speed sensor to
SERIAL. The monitor will get ground speed from the
serial cable connection to the Land Manager. Leave the
secondary speed sensor set to WHEEL and do not change
the Speed Sensor Pulses/100 ft. Also do not perform a
distance calibration using wheel selection. No calibration
is needed when primary speed is set to SERIAL.
Note: This setting affects all configurations.
App Distance From GPS: Set to distance between where
product exits applicator and position of GPS antenna on
vehicle. Example: If spray boom is 20 feet behind GPS
antenna set to 20 feet back. Press DOWN ARROW key to
set feet back, UP ARROW key to set feet forward.
Full Swath: Ignore setting. Swath automatically comes
from serial port of the DICKEY-john. The swath on the
PF automatically changes as boom sections are turned ON
or OFF.
Tgt Units: Contrler Units: Normally set to 1:1.0000.
This ratio is used to convert the units in a target file (.tgt)
to the units of application.