Operator`s manual

New Leader Controller
PFadvantage
Application Rate Mode
Ag Leader Technology
September 2003
2-76
Nominal Rate: If the PF is not controlling the rate, ignore this
setting. If the PF is controlling the rate, this setting must equal the
nominal rate
setting in the Mark processor.
Press the MODE key on the Mark processor until the nominal rate
appears. The nominal rate should appear as follows for the
different modes of the Mark processor.
"Yield = xxxx Lb/A" – Fert Mode
"Yield = xx.x T/A" – Lime Mode
Percent rate change: If the PF is not controlling the rate, ignore
this setting. If the PF is controlling the rate, this setting must
equal 6.66%.
Cal. number for act. Rate: Use the formula below to dtermine
this setting.
New Leader – Press Mode key on controller to view
“FeedGate=xx.xx”, “Mat’l=xxx.x Lb”, and “Conv. Rate=x.xxx”
settings. Use formula to determine cal. number.
Feed Gate x Mat'l x Conv. Rate x 1000 (5 if lime)
6.1
= cal. number
NOTE: When As Applied data is mapped in mapping program,
actual rate will be 1/10
th
of real actual rate (except for lime). If
cal. number is over 6400, divide cal. number by 10. Ex.
7000/10=700 (mapped actual rate will be 1/100
th
of real actual
rate). If feed gate setting changes, switch configurations and
enter new cal. number.
2. Press EXIT key to return to screen with ADVANCED SETTINGS
key on bottom. Press the ADVANCED SETTINGS key