Getting Started Guide Owner's manual

Note : Do not manually disconnect the lightbar from the receiver. The lost signal causes the lightbar to perform
an incorrect fast restart.
When the lightbar receives OmniSTAR corrections from a TSIP−compatible receiver, the convergence time is
reported differently.
Using RTK corrected positions over TSIP
When you use RTK positions from an external receiver, you can configure the network ID using the Network ID
setting.
On the main map screen, the Info tab shows a diagnostic called Link Quality . This describes the quality of the
radio signal, and as a result the RTK signal.
Depending on the quality of the signal coming in, the Link Quality item will show one of the following indicators:
Excellent•
Good•
Fair•
Poor•
70