User Manual

41
CHAPTER 6: APPENDIX
6.1 Warning Messages
Warning Messages Cause Solution
INPUT SIGNAL
OUT OF RANGE
The resolution or the refresh rate of
the graphics card of the computer
is set too high.
• Change the resolution or the
refresh rate of the graphics
card.
NO
SIGNAL
The LCD display cannot detect the
input source signal.
• Check if the input source is
turned ON.
• Check if the signal cable is
properly connected.
• Check if any pin inside the
cable connector is twisted or
broken.
OSD
LOCK OUT
The OSD has been locked by the
user.
• Unlock the OSD, refer to page
20.
ANTI-BURN-IN
ON
The Anti-Burn-In function has been
enabled by the user.
• Disable Anti-Burn-In function,
refer to page 34.
ANTI-BURN-IN
OFF
The Anti-Burn-In function has been
disabled by the user.
• Enable Anti-Burn-In function,
refer to page 34.