Specifications

FM774/0708 BOOK 2 15
CRR SERIES
2002 - 2005
Fault Finding for SP3216 and SP3219
• Remove 8 pin remote control receiver cable from rear of keypad and fault find as per CO/CZ/CA/CR/CY.
• If fault is attributed to remote control then replace the transmitter and re-programme the receiver
Programming additional transmitters
The receiver and transmitter supplied in the remote pack are pre-programmed. To attach additional
transmitters, program as follows:-
1. Power to remain connected.
2. Remove the cover from the receiver box and locate the ‘ADD’ pins and jumper.
3. Remove the jumper from the top pin and bridge the ‘ADD’ pins with the jumper. The Red LED will
illuminate.
4. Press each button on the transmitter once. The LED will flash once, indicating that the button press has
been accepted
5. Remove the jumper from the ‘ADD’ pins and replace it on the top pin.
Resolving a conflict situation
If the transmitter is operating other devices in the home (even a neighbour’s home), or another remote
transmitter operates the air conditioning , the transmitter will need to be replaced with a new one, and the re-
ceiver re-programmed.
1. With the power connected, bridge the ‘CLR’ pins with the jumper.
2. The LED will flash slowly 12 times, then stay on.
3. Remove the jumper. The LED will flash rapidly as the memory is erased.
4. Select a new transmitter and repeat ‘PROGRAMMING EXTRA TRANSMITTERS’ steps 3 to 5.
ADD
CLR
Remove
Jumper
ADD
CLR
Bridge ADD Pins
ADD
CLR
Remove
Jumper
ADD
CLR
Replace
Jumper
ADD
CLR
Bridge CLR pins with
jumper
ADD
CLR
Remove
Jumper