Installation Instructions

Fig. 20 DESN 516552

7. The hotcupboard top plate is set 1/4” (5mm) higher than the AGA Dual Control top plate. This is to prevent damage to

the enamel during installation. Lower the top plate using the adjusters (See Figs. 21 and 22).

Fig. 21 DESN 516554

6. Slide hotcupboard onto plinth until rear tongue bracket engages fully into rear of base slot, (See Fig. 20). Ensure the

appliance is aligned squarely with the plinth then proceed to engage the front tongue bracket into the slot on the under

side of the base plate. Once satisfied that the front tongue bracket is engaged fully lock it into place by tightening the

two M6 screws fully. Ensure that the electrical cable does not come into contact with oven vent pipe from the AGA

DC3.

1/4” (5mm)

DIFFERENCE