Owner's Manual
Table Of Contents
- 1. Important safety information
- 2. Range overview
- 3. Oven cooking guide
- 4. Cleaning your range
- 5. Troubleshooting
- 6. Installation Instructions
- 7. Service and parts
- 8. Installation safety instructions
- 9. Installation
- 10. Gas connection
- 11. Conversion to LP Gas
- 12. Electrical connection
- 13. Final fitting and checks
- 14. Circuit diagram
- 15. Technical data
33
INSTALLATION
Check the appliance is electrically safe when you have nished.
Fitting the drawer
NOTE: To avoid exterior damage to the storage drawer. Place
a soft cushioned mat on the oor.
To t the drawer, refer to Fitting the drawer on page 40.
n
Check the appliance is gas sound.
DO NOT use a ame to check for gas leaks.
When using test pressures greater than ½ psi (3.5 kPa)
to pressure test the gas supply system of the residence,
disconnect the range and individual shut-o valve from the
gas supply piping.
When using test pressures of ½ psi (3.5 kPa) or less to test
the gas supply system, simply isolate the range from the gas
supply system by closing the individual shut-o valve.
n
Check the operation of all the burners.