Owner's Manual

INSTALLATION

Check the appliance is electrically safe when you have nished.

Fitting the Handrail

1. Using the 2 mm Allen key supplied, loosen the two

retaining screws in the base and side of the handrail

support. Fit the handrail support onto the locating

bosses on the fascia (Fig. 14.1).

NOTE: The handle support should face upwards.

2. Push the support back against the fascia and tighten the

oneretaining screws. Repeat for the other side. Check

that each support is secure.

3. Locate the handrail onto the support tabs and, using

the 3 mm Allen key supplied, tighten the one retaining

screws in the bottom to secure (Fig. 14.2).

Fitting the Interlocking Grates

Please note that the Continuous Grates supports are handed,

and may prevent the centre pan supports from tting

correctly. There is a small indent in the rear of each of the

outer supports. This indent should be towards the outer edge

of the range (Fig. 14.3).

Cooktop Check

Check each cooking zone in turn. Be sure to use pans of the

correct size and material.

Broiler Check

Turn on the broiler control and check that the broiler heats

up.

n

Make sure the broiler area is clear of all packaging.

Oven Check

Turn on the oven. Check the oven fans start to turn and that

the oven heats up.

Customer Care

Installer: Please complete your details in this guide, inform

the user how to operate the range and hand over the

instructions.

14. Final Fitting

Retaining screw

Retaining

screw

Fig. 14.1

Fig. 14.2

Fig. 14.3