Use and Care Guide

38
INSTALLATION
Check the appliance is electrically safe when you have nished.
ArtNo.010-0004 Moving the cooker
Alternative positions
for anti-tip device
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability bracket
Floor
3 mm min
Typical oor mounting
Fitting the anti-tip device
1. A suitable anti-tip device is supplied and shown in
(Fig. 12.23).
2. When tting the anti-tip bracket (Fig. 12.23 and
Fig. 12.24), adjust the bracket to give the smallest
practicable clearance between the bracket and the
engagement slot in the rear of the range.
3. Fit the bracket so that it engages as far as possible over
the chassis of the range.
n
DO NOT operate the range before the appliance is
in its installed position and the anti-tip devices are
engaged.
n
If the appliance is moved ensure that the anti-tip
devices are re-engaged and the range has been
returned to its original installed position.
n
DO NOT step, lean or swing on the range doors
or drawer as this could tip the range and result in
serious injury or death.
Completing the move
1. Open the broiler door and right-hand oven door so that
you can get a good grip on the bottom of the fascia
panel as you move the range (Fig. 12.25).
2. Position the range close to its nal position.
3. Check that the anti-tip device is engaged before moving
the range into its nal, installed position.
4. Re-check that the appliance is level.
n
DO NOT use the door handles or control knobs to
manoeuvre the range.
0
1
⁄
8
" (3 mm) min
Fig. 12.23
Fig. 12.24
Range
Anti-Tip bracket
Fig. 12.25