Owner's Guide

32
INSTALLATION
Check the appliance is electrically safe when you have nished.
Fitting the Front Mounting
Brackets
1. Open the right-hand oven door and pull the drawer out
to its furthest point.
2. Push the ends of the plastic clips (Fig. 10.13 and Fig.
10.14) to release the catches holding the drawer to the
side runners. At the same time pull the drawer forward
and away from the side runners.
n
For safety’s sake make sure the drawer runners are
out of the way.
3. On the front of the range base there are two mounting
plates. Remove the three xing screws from each plate
(Fig. 10.15).
4. Fit the left and right-hand front mounting brackets
as shown in (Fig. 10.15). DO NOT over tighten the
mounting screws at this stage.
Fig. 10.13
Down on the left-hand side. Up on the right-hand side
Fig. 10.14
Fig. 10.15
Left front view at the base of the range Right front view at the base of the range
Left Mounting
Plate
Right Mounting
Plate