Dishwasher Elise Installation Guide

16
17
INSTALLER CHECKLIST AND FINAL INSTRUCTIONS
Your installer must have completed and checked the following:
□ The dishwasher is square and level.
□ The dishwasher is fastened securely to the cabinetry.
□ The dishwasher door opens and closes freely. The dishwasher door must close without hitting any
cabinetry or countertop.
□ The inlet water supply is turned on and checked for leaks.
□ The drain hose has been connected and checked for leaks. There must be no kinks or obstructions in
the drain hose.
□ The drain hose must be installed with a 28" (710mm) high drain loop for drain hook-ups without any air
removed.
□ If the dishwasher drain is hooked up to a garbage disposal, the drain hopper plug must be removed.
□ The spray arms are free and rotate freely.
□ The rinse cycle has been run.
□ The water level will be below the lter screen after the end of the wash program. It is normal to nd
some water in the drain lter area.
□ Set the water softener to the correct water hardness for your area. If the dishwasher drain is connected
to a garbage disposal, make sure that the drain/hopper plug has been removed.
Final Instructions
• Press the On/Off button to turn the dishwasher on.
• Power indicator light comes on.
• Use the Program Select button to choose a washing program.
• Start the program with the Start/Pause/Cancel button.
• Run the dishwasher through one complete cycle. When the wash cycle is completed, use the On/Off
button to turn the dishwasher off.
Self-Help Hints
The screen does not come on:
• Check to make sure the breaker to the dishwasher is in the on position.
• Check to make sure that the supply cord is plugged.
No water is coming into the dishwasher:
• Check to make sure the hot water shut-off is in the ON position.
Water does not drain:
• Make sure drain hose is not kinked or comes out of air gap next to the sink.
• Remove drain hose from disposal making sure plug is removed.