Owner's Manual
Table Of Contents
- 1. Important safety information
 - 2. Range overview
 - 3. Oven cooking guide
 - 4. Cleaning your range
 - 5. Troubleshooting
 - 6. Installation Instructions
 - 7. Service and parts
 - 8. Installation safety instructions
 - 9. Installation
 - 10. Gas connection
 - 11. Conversion to LP Gas
 - 12. Electrical connection
 - 13. Final fitting and checks
 - 14. Circuit diagram
 - 15. Technical data
 
5
0
100
140
180
220
0
1
33
22
1
0
00000
A
B
C
D
The dual fuel single cavity range (Fig. 2.1) has the following 
features:
A.  5 hotplate burners
B.  Control panel
C.  Multifunction oven
D.  Storage drawer
Cooktop burners
Note: Before using the cooktop make sure all burners are in 
place and all the grates on the range are properly placed.
The drawing by each knob indicates which burner that knob 
controls (Fig. 2.2).
Each burner has a special Flame Supervision Device (FSD) that 
stops the ow of gas if the ame goes out.
To light a burner push in and turn the associated control knob 
to the high position as indicated by the large ame symbol 
(
) (Fig. 2.3).
Keep holding the knob pressed in to let the gas through to 
the burner for about 4 seconds (Fig. 2.3). The igniter should 
spark and light the gas. 
When a cooktop burner knob is pressed in, sparks will be 
made at every burner – this is normal. DO NOT attempt 
to disassemble or clean around any burner while another 
burner is on: an electric shock could result.
2.  Range overview
Fig. 2.1 
Fig. 2.2 
Fig. 2.3 










