User and Installation Guide

INSTALLATION
Check the appliance is electrically safe when you have nished.
25
Converting to propane gas
This appliance is supplied set for natural gas.
A conversion kit for Propane gas is supplied with the range.
If the appliance is to be converted this must be done before
installation. The conversion must be performed by a qualied
LP gas installer. See the ‘Conversion’ section at the back of this
installation manual for more details.
n
For installation 5000 ft above sea level the appliance
must be converted using high altitude kit A065744.
Contact your distributor.
Location of the range
The range may be installed in a kitchen/kitchen dining area
but NOT in a room containing a bath or shower.
The range is freestanding and should not be placed on a
separate base.
DO NOT locate the range where it may be subject to strong
drafts. Any openings beneath the range or behind the range
should be sealed.
The range should be positioned on a solid substrate.
n
Your range is heavy DO NOT place on soft oor
coverings, such as cushioned vinyl or carpeting.
Use care when moving the range on cushioned vinyl or
carpeted ooring.
When the oor covering ends at the front of the range, the
area that the range will rest on should be built up to the same
level or higher than the oor covering.
n
IMPORTANT - This will allow the range to be moved
for cleaning or servicing. Also, make sure your oor
covering will withstand 180°F. (See the Installation
Safety Instructions section).
n
IMPORTANT - Make sure the wall coverings around
your range can withstand the heat generated (up
to 200°F) by the range. (See the Installation Safety
Instructions section).