Manualshelf

User Guide

ManualsBrandsAGA ManualsAga VentilationAMCHD36SS AGA 36" Wall Mount Vent Range Hood with Halogen Lighting and Adjustable Duct Covers - 600 CFM - Stainless Steel
12345678910
EN
8
8
8 4/16”
X
INSTALLATION
Wall drilling and bracket fixing
Wall marking:
• Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the center of the area in which the hood
will be installed.
• Draw a horizontal line at 24” above the cooktop for installation without the back panel, or at height H (height of the visible part
of the panel) for installation with the back panel.
• Place upper bracket 7.2.1 on the wall as shown about 1/16” from the ceiling or upper limit, aligning the center (notch) with the
vertical reference line.
• Mark the wall at the centers of the holes in the bracket.
• Place lower bracket 7.2.1 on the wall as shown at X” below the first bracket (X = height of the upper chimney section supplied),
aligning the center (notch) with the vertical line.
• Mark the wall at the centers of the holes in the bracket.
• Mark a reference point on the horizontal reference line as indicated, 4 5/16” from the vertical reference line and 8 4/16” above
the horizontal reference line.
• Repeat this operation on the other side.
• Drill ø 5/16” holes at all the centre points marked.
• Insert the wall plugs 11 in the holes.
• Fix the brackets using the 12a screws supplied.
• Insert the two screws 12a supplied in the hood body fixing holes, leaving a gap of 3/16” between the wall and the head of the screw.
REAR PANEL (OPTIONAL)
The Rear Panel must be fitted before fixing the hood body and, if it is to be fixed at both top and bottom, must be fitted at the cor-
rect height prior to installing the bases. As this operation is rather complex, it should be carried out either by the kitchen installer or a
qualified person who knows the final dimensions of the units.
For fixing at the top only, proceed as follows:
• Rest the back panel on the base, inserting the lower plate between the upper surface and the wall, centering it on the vertical
reference line.
• Mark the centers of the two holes in the upper plate.
• Drill ø 5/16” holes at all the centre points marked.
• Insert the wall plugs 11 in the holes.
• Fix the brackets using the 12a screws supplied.
• Fix the back panel (where present) using the 12a screws supplied.