Specification Sheet

AGA Professional Stainless Steel Dishwasher
Model # AMPROTTDW
3
Specifi cations are subject to change without notice. Visit www.aga-ranges.com for the most up-to-date information.
Built-In Panel-Ready Dishwasher Specifi cations
• Product Weight – 98 Lbs.
• Voltage Rating – 120V/60Hz
• Connected Load (kW Rating) @120 Volts = 1.44 kW (For use on
adequately wired 120V, dedicated circuit having 2-wire service with a
separate ground wire. Appliance must be grounded for safe operation.)
• Amps @ 120V = 15.0
• Always consult local and national electric & plumbing codes.
Meets requirements of ASSE 1006 — integral air gap on supply.
• Water Pressure – Hot water line to dishwasher must provide between
20 and 90 pounds per square inch (psi) with at least 120° F hot water
temperature.
• Make sure location has correct drain, water and electrical outlets to
make connections.
• Electrical and water supplies should enter cabinet opening on fl oor, or
through back or side walls, as shown in shaded areas.
• Keep back free of drain, water & electrical supply.
• Connections preferably located toward left side of dishwasher. Do not
cross drain, water or electrical lines in front of motor, blower or frame.
• If connecting drain hose to sink trap, local code may require installation
of Air Gap Kit (not included).
• Leveling legs supplied to adjust height. Note: Height only adjustable
to 35-¾" max. when installed in 35-3/4" max. standard cabinetry
cutout. 5/16" min. clearance required from top of unit to underside of
countertop.
Dimensions do NOT include insulation — insulation blanket may be
compressed during installation.)
• When installing adjacent to wall, cabinet or other obstruction that
extends beyond front edge of unit, allow 2" minimum clearance
between opened door and obstruction.
• Floor should be fl at and free of obstructions.
• When installing at end of cabinet line, sides and back must be fully
enclosed.
• Do not install unit under a cooktop, damage will occur.
• Recommended to seal cabinets, enclosing all sides of dishwasher,
including underside of countertop, with oil-based paint or moisture-
proof polyurethane to prevent possible steam/moisture damage.
Custom Panel Specifi cations
Refer to web for detailed panel construction and installation instructions.
Pilot-hole paper template and screws provided for proper panel
installation.
• Handle not included, match to custom cabinetry. Fit handle onto
custom panel according to manufacturer’s instructions. Handle should
be used versus knob to provide adequate grip.
• Panel Dimensions – 30½" H max. x 23-¾" W x¾" D max.
• Panel Weight – 12 Lbs. max.
Installation