Dimensions Guide

ManualsBrandsAGA ManualsSingle Oven Dual Fuel RangesAPRO30DFSS

AGA Kitchen Concierge

800-525-5601

#AGAProPower www.aga-ranges.com

aga_professional_30_inch_df_range_spec_sheet_apro30dfss.pdf - pub 1/2016 rev 1

INSTALLATION

Check the appliance is electrically safe when you have nished.

Positioning the Range

Fig. 7-1 shows the minimum recommended distances and

clearances from the range to nearby surfaces.

You MUST provide adequate clearances between the range

and adjacent combustible surfaces. These dimensions MUST

be met for safe use of your range.

The location of the electrical outlet and pipe opening (see

Fig. 8-1on page 19) may be adjusted to meet specic

requirements.

A gap of at least 10” (25.4 cm) should be left between each

side of the range ABOVE the cooktop level and any adjacent

vertical surface.

The cooktop surround should be level with, or above, any

adjacent work surface.

The maximum depth for cabinets installed above cooktops is

13’’ (33 cm).

The depth of the range is 27 ½’’ (70 cm) overall (Fig. 7-2).

Any range hood should be installed in accordance with the

hood manufacturer’s instructions.

Any splashback must be tted in accordance with the

manufacturers instructions. Allowance should be made for the

additional height of the ue trim, which is tted to the cooker

hob.

For safety reasons curtains must not be sited immediately

behind the range.

We recommend a gap of 30” (76.2 cm) – 30 ½” (77.5 cm (for

Canada 31” (79 cm)) between cupboards to allow for moving

the range.

USA only: If a ush t is required, install the range up to the

cupboard at one side then install the cupboard the other side.

Fitting the Anti-Tip Bracket

n

WARNING: The range must be secured by the anti-

tip bracket supplied. Unless properly installed, the

range could be tipped by leaning on the door. Injury

might result from spilled hot liquids or from the

range itself.

Using the bracket and screws supplied, x the bracket to the

wall (Fig. 7-3). Ensure the stability pin locates beneath the

bracket when the range is in position.

ArtNo.280-0001 36” wide oven dimensions

Min 30” (76.2 cm) / Max 36” (91.4 cm)

between the top of the cooktop

and the bottom of an extraction hood

Max 13”

(33 cm)

Min 30” (76.2 cm) - 30½“ (77.5 cm)

recommended to allow for moving the range.

For Canada, min 31” (79 cm)

36” (91.4 cm)

Min 18”

(45.5 cm)

*A gap of at least 10” (25.4 cm) should be left between each side of the range

above the cooktop level and any adjacent vertical surface.

30”

27½”

36”

39¾”

44¼”

Fig. 7-1

Fig. 7-2

Fig. 7-3

Stability pin

Stability bracket

Standard Installation