Manualshelf

Installation Guide

ManualsBrandsAGA ManualsAGA 24" Companion RangesATC2DFCRM AGA 24" Freestanding Dual Fuel Range with 4 Sealed Burners and 4.9 cu . ft Oven Capacity - Cream
11121314151617181920
13
CONNECTION TO THE POWER SUPPLY
Electric Shock Hazard
Rating Plate is located behind removable plinth, see Fig. 11.
Electrical Grounding is required on this appliance.
DO NOT connect to the electrical supply until the appliance is permanently grounded.
This appliance must be connected to a grounded metallic permanent supply or a grounding
connector should be connected to the grounding terminal or wire lead on the appliance.
Failure to follow these instructions could result in death or serious injury.
This range must be supplied with a 240V, 60Hz power supply and connected to an individual, properly grounded branch
circuit protected by a circuit breaker. At 240V, it has a maximum load of 18 amps. Electric hook-up must be done by a
licensed electrician. This unit must be installed according to local codes, or in the absence of codes, the National
Electrical Code.
l Product installation requires a separate (not shared) 240V/20 amp circuit protected by an appropriate branch circuit
supply.
l The power cord on your range is fitted with a standard four (4) conductor type 14-50P plug (matching receptacle
14-50R).
The method of connection to the mains electricity supply must facilitate complete electrical isolation of the appliance.
The mains connection and isolation should not be positioned above the range and must be positioned within the area
defined in Fig. 11, Page 14.
A fully recessed range connection box may be located immediately behind the range (in the hatched area only as shown
in Fig. 11). A gap of
3
/16” (5mm) must be allowed at the rear of the range.
THIS RANGE MUST BE COMPLETELY ISOLATED FROM THE ELECTRICITY SUPPLY BEFORE SERVICING. THE
RANGE IS DESIGNED FOR THE VOLTAGE STATED ON THE RATING PLATE, WHICH IS SITUATED BEHIND THE
PLINTH COVER.
WARNING
Electrical Grounding Instructions
This appliance is equipped with a 4 prong grounding plug for your protection
against shock hazard and should be plugged directly into a properly grounded receptacle.
Do not cut or remove the grounding prong from this plug.