User Instructions

AGA TOTAL CONTROL OPERATING MODES
The appliance has 4 operating modes:
Mode Selection Button
Manual Slumber AUTO AUTO/Slumber
selection can only be made when standby button is on.
Standby Button
This button must be on i.e. green to operate any part of your AGA
Total Control, or for any Timed events.
Manual simply select what you require
Each heat zone (an oven or a hotplate) can be turned on or off as
required, just press the appropriate button, a green light will show
when a specific zone is in operation.
The green indicator light of the selected zone (s) will flash slowly
indicating that the zone (s) is warming up. Once the selected
zone (s)
is at temperature and ready to use the green light will stop
flashing. It is normal for the green light to flash slowly during
cooking, this indicates that the heat zone is requesting power. While
in Manual mode any zone selected will remain on indefinitely until
switched off.
Slumber (ovens only)
In this mode, all three ovens are active, (the roasting and baking
oven are pre-set to approximately 248°F, the slow cook oven is
pre-set to approximately 212°F).
When selected, the orange indicator light of the ovens will flash
slowly, indicating that the ovens are warming up, when ‘Slumber’
temperature is reached the orange light will stop flashing.
No individual oven can be ‘OFF’. However any oven can be switched
from ‘Slumber’ to full heat by one press of its button. When pressed
once, the selected oven goes to ‘full heat’, there will be a flashing
green light, when at temperature the light will stop flashing.
Pressing an individual oven button once more returns that oven back
to ‘Slumber’.
AUTO (ovens only) - brings selected ovens up to full
heat from OFF
The ovens can be selected to operate once or twice each day.
Each operation is termed an ‘event’, the start and finish time is
chosen by you unless you use the pre-set time.
The handset will have been set up by the installer. It should have the
correct time of day set. Unless you have set your own Auto
program, it will include the pre-set time (1 Event 7am - 7pm).
See Page 14 to set your own Auto program preferences.
Select ‘AUTO’ mode.
Select oven (s) for automatic operation, by pressing the appropriate
button (s).
The oven (s) selected is indicated by an orange light (unless you
have selected ‘AUTO’ during an ‘event’ period). During an ‘event’
period the light will be green.
The oven light will flash green while the oven is heating. When at
temperature the green light will stop flashing.
PLEASE NOTE:
• Don’t forget to include time for warm-up.
• Don’t forget if you have set the AUTO program and have
selected the AUTO mode, an oven or ovens must be selected
.
• The hotplates can only be operated manually.
• The last ‘AUTO’ oven selection is remembered and re-called
when ‘AUTO’ is next selected.
•
DO NOT OPERATE WITH THE APPLIANCE DOORS
OPEN
9