TRADITIONAL HOOD ATHOOD Instructions Manual
INDEX EN RECOMMENDATIONS AND SUGGESTIONS ..................................................................................................................... 3 CHARACTERISTICS ............................................................................................................................................................. 4 INSTALLATION.................................................................................................................................................................
RECOMMENDATIONS AND SUGGESTIONS The Instructions for Use apply to several versions of this appliance. Accordingly, you may find descriptions of individual features that do not apply to your specific appliance. INSTALLATION • The manufacturer will not be held liable for any damages resulting from incorrect or improper installation.
CHARACTERISTICS Dimensions Components Ref. Q.ty 1 1 2 1 2.1 1 2.2 1 8a 1 8b 1 9 1 10 1 15 1 Ref. Q.ty 7.1 2 7.2.
INSTALLATION 1÷2 Wall drilling and bracket fixing 190 109,5 109,5 H 650 min. 7.1 X 7.2.1 Wall marking: • Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area in which the hood will be installed. • Draw a horizontal line at 650 mm above the hob for installation without the back panel, or at height H (height of the visible part of the panel) for installation with the back panel. • Place bracket 7.2.
Mounting the hood body 12.d • Screw the two screws 12d supplied onto the brackets 7.1. • Hook the hood body onto the bracket 7.1, centring it around the vertical line. • Use the adjusting screws 12d underneath the hood to level the hood body. 7.1 Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 125 mm, the choice of which is left to the installer.
ELECTRICAL CONNECTION • Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. s (see paragraph Maintenance) being • Remove the grease sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the fan. Fitting the styling rail • Fit the rail over the front of the cookerhood. • Fit the Allen headed bolts through the rail end support fixing holes and secure to cookerhood.
USE 3 1 2 0 1 0 1 V L M L Light Switches the lighting system on and off M Motor Switches the extractor motor on and off V Speed Sets the operating speed of the extractor: 1. Low speed, used for a continuous and silent air change in the presence of light cooking vapour. 2. Medium speed, suitable for most operating conditions given the optimum treated air flow/noise level ratio. 3. Maximum speed, used for eliminating the highest cooking vapour emission, including long periods.
MAINTENANCE Grease filters CLEANING METAL GREASE FILTERS The filters are washable at least every 2 months of operation, or more frequently for particularly heavy usage. • Remove the filters one at a time by supporting them with one hand and turning the safety knobs (pull and turn). • Wash the filters, taking care not to bend them. Allow them to dry before refitting. • Refit them and fix them using the safety knobs provided (pull and turn).
436005756_ver1 F200070
