Technical data

OVEN THERMOCOUPLE

Fig. 7 DESN 515277

NOTE: On AIMS controlled cookers the thermostat phial (probe) has

been replaced by an oven thermocouple sensor, which is fitted to the

PCB on the controls chassis. (See Fig. 2).

1. Feed the thermocouple sensor through the guide tube into the

Roasting oven.

2. Fit the thermocouple sensor to the support plate so that the sensing

tip is as shown in (See Fig. 7). DO NOT OVERTIGHTEN the clamp as

this may damage the sensor. Screw support plate to top of roast oven.

3. When assembling the controls chassis to the burner housing:-

Ensure that the thermocouple sensor goes through the notch in the

top rear of the panel, and that the sealed pot is below the notch (i.e.

sealed pot must not be trapped between mounting chassis and

mesh shield).

Fig. 8 DESN 515284