User guide

The handset is designed to operate within the kitchen area.

When transferring information from or to the controller always operate the handset in

front of the cooker, this gives the strongest signal.

If the handset indicates ‘OFFLINE’, press the back button firmly, this will activate the

communication link between the cooker and handset.

Should the handset continue to show ‘OFFLINE’, allow one minute for the handset to

“automatically”, re-connect itself with the cooker.

AIMS (AGA INTELLIGENT MANAGEMENT SYSTEM)

CONTROLS

Fig. 7 DESN 515282

1. Connect the electricity supply.

2. Turn the right hand control knob from the OFF setting to the Normal manual control

setting. The cooker will heat up until it reaches the Normal temperature as

indicated by the black line on the heat indicator.

3. The left hand control knob will alter the oven temperature. Turn it clockwise to increase the

temperature and anti-clockwise to decrease the temperature.

To obtain the required roasting oven temperature of 240°C this control knob will need to be

set about halfway. We recommend that the cooker is run on the Normal manual setting

for two days, before switching to AIMS (automatic control).

4. When the Normal temperature has been set with heat indicator on or near the black line, it

should not be necessary to alter the temperature control again.

5. The cooker can now be switched to AIMS (automatic control), by turning the right hand

control knob from the setting to the AIMS setting.

6. The AIMS hand set can then be used to programme the required settings (see AIMS

(automatic)) control instructions.

AIMS SET-UP (SEE FIG. 7)

AIMS CONTROLLER HANDSET