Troubleshooting guide
13
interior will have excessive moisture. e heat dry option will
not perform as well without rinse aid.
• Rinse aid keeps water from forming droplets that
can dry as spots or streaks. ey also improve
drying by allowing water to drain o of the dishes
after the nal rinse.
• Rinse aid helps to reduce excess moisture on the
dish racks and interior of your
dishwasher.
• Check the rinse aid indicator. Add
rinse aid when indicator drops to
“Add” level.
• To add rinse aid, turn the dispenser
cap to “Rell” and lift o. Pour
rinse aid into the opening until
the indicator level is at “Full.”
Replace the dispenser cap and turn
to “Lock.” Make sure cap is fully
locked.
Step 3
Select a Cycle
See “Cycle and Option Descriptions” charts in the following
section.
Heavier cycles and options aect cycle length. Some cycles and
Select Options
See “Cycle and Option Descriptions” charts in the following
section.
You can customize your cycles by pressing the options desired.
Step 4
• Run hot water at the sink nearest your dishwasher
until the water is hot. Turn o water.
• Push door rmly closed. e door latches
automatically. Select the wash cycle and options desired OR
press START/RESUME to repeat the same cycle and options as
in the previous wash cycle.
• You can add an item anytime before the main wash starts.
Open the door slowly and add the item. Close the door rmly.
Press START/RESUME.
Full
Add
⁄
turn to lock
Lock
Rell
?
?
?
?
?
?
?
?
???
????
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
???
????
?
?
?
?
?
?
?
?
?
?
?
?
?