Troubleshooting guide

15
Option Selections
Options Dish Load Types Descriptions Use With:
Pans, casseroles, etc. with
tough food soil.
Activates the PROSCRUB® spray jets and provides
intensified water spray to the back of the lower level rack.
May add heat and time to the cycle.
Heavy Duty or Normal cycle
To sanitize your dishes and
glassware in accordance
with NSF/ANSI Standard
184 for Residential
Dishwashers.
Raises the water temperature in the final rinse to
approximately 155°F (68°C). This high temperature rinse
sanitizes your dishes and glassware in accordance with
NSF/ANSI Standard 184 for Residential Dishwashers.
Certified residential dishwashers are not intended for
licensed food establishments.
The Sanitize or Sani Rinse option adds heat and time to
the cycle.
Normal cycle. Heavy Duty
cycle automatically uses Sani
Rinse. Only these sanitization
cycles have been designed
to meet the NSF/ANSI
requirements.
Loads containing tough,
baked-on food.
Increases the target water temperature during the wash
portions of the cycle. Adds heat, wash time and water to
the cycle.
Heavy Duty or Normal cycles
For best drying results, dry
dishes with heat.
Turn OFF when loads contain plastic dinnerware that
may be sensitive to high temperatures. This option
with the use of rinse aid will provide the best drying
performance.
All cycles, except Rinse Only.
Automatic with all wash cycles
unless you turn it off.
To run your dish washer
at a later time or during
offpeak hours.
Delays the start of a cycle up to 4 hours.
Select a wash cycle and options. Press 4 Hour Delay. Press
START/RESUME. Close the door firmly.
All cycles, except Rinse Only
Control
Lock
To avoid unintended use of
your dishwasher, or cycle
and option changes during
a cycle.
To turn on Lock, press and hold Heat Dry for at least 4
seconds.
To turn off Lock, press and hold Heat Dry for at least 4
seconds.
When Control Lock is lit, all buttons are disabled. If you
press any pad while your dishwasher is locked, the light
flashes 3 times. The dishwasher door can be opened while
the controls are locked.
Anytime
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts thecycle
for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle will
automatically compensate by adding time, heat and water as needed.
Controls and Cycle Status
Control Purpose Comments
To start or resume a wash
cycle
If the door is opened during a cycle or the power is interrupted, the Start/Resume indicator
flashes. The cycle will not resume until the door is closed and Start/Resume is pressed.
To cancel wash cycle Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let the
dishwasher drain completely.
To follow the progress of
your dishwasher cycle
Clean indicator glows when a cycle is finished.
If you select the Sani Rinse option, when the Sani Rinse cycle is finished, the Sanitized
indicator glows. If your dishwasher did not properly sanitize your dishes, the light flashes at
the end of the cycle. This can happen if the cycle is interrupted, or the water could not be
heated to the required temperature. The light goes off when you open and close the door or
press CANCEL.