Installation Manual

Fig. 7A DESN 516858
FOR AGA TC5/DC5 + MODULE ONLY
7. Prior to electrical connections, remove top plate assembly from Module as follows:-
a) Remove pan supports and all controls knobs.
b) Remove four chrome buttons and the four top plate retaining screws (2 each side).
c) Remove two screws from control panel (one from left hand hole and one from centre hole). (See Fig. 8).
d) Pull top plate forward slightly and lift up at front. Support top plate and disconnect wiring to the two neons. Remove
top plate.
e) Lay the top plate on its top face, suitably protected.
DESN 511645
REMOVE 2 FIXING SCREWS
Fig. 8
14