Installation Manual

Fig. 10 DESN 517044
15. Apply tape (provided) to the rear of the lap strip on the Module front plate.
16. Slide Module onto plinth until rear tongue bracket engages fully into rear of base slot. (See Fig. 10). Ensure the
appliance is aligned squarely with the plinth. Check that the Module front plate and AGA Total/Dual Control front plate
are the same height, and that the overlap strips correspond correctly. If not, adjustment should be made to the relevant
appliance at this stage.
Then proceed to engage the front tongue bracket into the slot on the underside of the base plate, and lock into place
by tightening the two M6 screws fully.
17