Installation Manual

21. Once the handrail assembly is located squarely, lock the handrail in position by tightening the grub screws on the
underside of each handrail bracket.
22. Once the handrails are locked in position, fit the handrail endcaps. The endcaps should be carefully pushed into place
until they sit flush with the outside face of each bracket (a light smear of lubricant such as, hand soap on the end cap
‘O’ rings may ease fitment.
23. Finally, fit the plinth facia to the magnets on the front of the plinth, making sure that the right hand side of the Module
plinth facia sits against the left hand side of the AGA Total Control or AGA Dual Control plinth facia leaving no gap
between. Also,make sure that the plinth facias are centrally located and do not overhang either appliance.
(See Fig. 14).
Commission the AGA Total Control or AGA Dual Control, as stated in the relevant Installation Instructions and carry out
functional test on each of the features of the Module.
21