Manualshelf

Installation Manual

ManualsBrandsAGA ManualsCooking Appliances24 Inch Freestanding Dual Fuel Liquid Propane Range with Convection, Infrared Broiler, Four-Ring Burner, 4 Sealed Burners, 4.9 cu. ft. Total Oven Capacity and Special Oven Linings: Pearl Ashes
21222324252627282930
DISCONNECT FROM ELECTRICITY SUPPLY BEFORE SERVICING.
WHEN RE-WIRING ANY ELECTRICAL COMPONENTS REFER TO CIRCUIT DIAGRAM AND ELECTRICAL SCHEMATIC
DIAGRAM ATTACHED BEFORE ELECTRICAL RECONNECTION CHECK THAT THE APPLIANCE IS ELECTRICALLY
SAFE.
NOTE: TURN OFF GAS SUPPLY TO RANGE BEFORE SERVICING ANY GAS CARRYING COMPONENTS. ALWAYS
CHECK APPLIANCE FOR GAS SOUNDNESS AFTER COMPLETION.
NOTE: USE SOAPY WATER SOLUTION TO ENSURE THERE ARE NO GAS LEAKS.
A. REMOVAL OF TOP PLATE
1. Disconnect from electricity supply and remove pan supports and control knobs.
2. (a) Remove the handrail from the module top plate.
(b) Remove shroud (if fitted) from rear of top plate.
(c) Remove four chrome buttons and the four top plate retaining screws (2 each side).
3. Remove left hand and centre grommets from the control panel to gain access to the fixing screws.
Remove two screws from control panel (one from left hand hole and one from centre hole (See Fig. 8).
4. Carefully pull top plate forwards slightly and lift up at the front. Support top plate and disconnect the wiring to the neons.
Remove top plate.
5. Lay the top plate on its top face, suitably protected.
6. Re-assemble in reverse order.
B. REMOVAL OF HOTPLATE
1. Repeat operations 1 to 5 of section ‘A’.
2. Remove burner heads and burner caps.
3. Remove all of the screws retaining hotplate burner trims (4 from the Wok burner, 2 each from the other three burners).
4. Carefully remove burner trims and gaskets, taking care not to damage gaskets or burner electrodes.
5. Disconnect earth wire from left hand control panel mounting bracket.
6. Remove hotplate.
7. Re-assemble in reverse order, ensuring burner heads and burner caps are correctly located and electrodes are not
damaged. (See Figs 15, 15a, 15b).
C. TO CHANGE IGNITION GENERATOR
1. Turn off electricity supply.
2. Remove top plate and hotplate (See sections A and B).
3. Remove two screws retaining the generator fixing bracket to the burner mounting panel, and remove generator.
(See Fig. 16).
4. Carefully remove all wiring from ignition generator (Fig. 16).
5. Re-assemble in reverse order and check operation of ignition to hotplate burners.
SERVICING NOTES
22