Installation Manual

11. Assemble a U.L.-listed strain relief in the opening.
12. Insert the power supply cord through the strain relief, allowing enough slack to easily attach the wiring to the terminal
block.
13. Use only ring-type terminals to connect the power supply. To secure the power supply cord use 6mm (1/4”) brass
terminal nuts attached to the inside of the terminal block cover. Be sure nuts are installed tight.
14. Complete electrical connection.
L1
WHITE
(NEUTRAL)
GREEN
(GROUND)
L2
Fig. 9
DESN 511752
16
9. Remove the terminal block cover screws located on the back of the range.
10. Make the four-wire connection following the “Power supply cord method”.
Power supply cord method
This range is manufactured to use a four-wire power supply cord rated at 250-volts, 30-amperes (See “Four wire electrical
connection”).