Product Manual

23
AGD 343
HIGHWAYS MONITORING RADAR
AGD 343
HIGHWAYS MONITORING RADAR
AGD 343
HIGHWAYS MONITORING RADAR
AGD 343
HIGHWAYS MONITORING RADAR
Troubleshooting
PHYSICAL INSTALLATION
If the unit is not operating correctly, please check the following, has the unit been:
1) Mounted within the recommended height of 6 metres?
2) Angled according to the installation guide to provide good coverage of the detection area?
3) Installed with any obstructions in the viewable area?
ELECTRICAL INSTALLATION
If the unit is not operating correctly, please check the following:
1) Is power present at the unit?
2) Is the red LED illuminated when power is applied to the unit?
3) Is there suicient current to run the unit - identified by the red LED failing to flash or flashing only once
during power-up and the web page not starting correctly? Refer to technical specification table.
CONNECTING / COMMISSIONING
If the unit is not operating in the prescribed manner, please check the following:
1) Is the LED on the front of the unit you wish to connect to illuminated blue to show that the WiFi network is
successfully connected?
2) Has the correct IP Address been entered into the browser address bar?
3) Have you followed the AGD Align Touch-setup stages correctly and verified correct operation?
If trouble with operation persists please contact AGD Technical Support.
AGD TECHNICAL SUPPORT
eMail: [e-mail]
Tel: [phone]