User Instructions
Table Of Contents
RFbeam Microwave GmbH
© RFbeam Microwave GmbH www.rfbeam.ch
Page 4/5
Connector Pinout
On module side a Samtec HW-04-15-F-D-325-SM connector with the following pinout is used:
1: /Enable Enable/Disable RF-part. Connect to 0V for normal operation
2: +3.3V Power Supply. Connect to +3.3V (3.15V .. 6.0V)
3: GND Ground connection. Connect to 0V
4: Q Out Analog Output Q-Channel
5: I Out Analog Output I-Channel
6: VCO Frequency control input. A voltage between 1..5V adjusts
TX Frequency by 0 .. 50MHz. Can be used for FSK or FMCW
7: S&H Sample&Hold Switch Analog Output. Leave it open or connect
to +3.3V for normal operation
8: Temp Temperature Sensor output of LMT84 temperature sensor
Mechanical Drawing
FCC Labelling Information: (label to be placed into the recess position * shown in the
mechanical drawing above
FCC ID: WH3 -MC-133
AGD-T7813-125 (MC-133)
Frequency 24.125GHz
Issue 1
Serial No: in barcode or datamatrix format
*
Datasheet
AGD-T7813-125 Issue ‘1’ MC-133