User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
131
2900H EN 20071108 Advanced operation (Key-operator mode)
DRYSTAR 5500/5503 REFERENCE MANUAL
Example: If the IP-address is 120.000.120.120, then the data entry should be as
follows:
Example: If the IP-address is 120.0.120.120, then the data entry should be as follows:
4 Press the Confirm key to continue, or the Escape key to return to the previous
step.
The ‘Enter Netmask’ screen is displayed:
If the net mask has already been assigned, it will be shown on the display.
5 Press the Up/Down arrow keys to increment/decrement the numbers. Press the
Left/Right arrow keys to move through the fields.
Example: If the netmask is 120.000.120.120, then the data entry should be as follows:
When no DHCP server is available and when the subnet mask of the printer has
never been set, the subnet mask will be set to the APIPA address 255.255.0.0.
Refer to ‘Data entry’ on page 33.
Note that blank spaces will not be filled in.
12 .00 .12 .12
12 . .12 .12
Blinking
e.g. 255.255.252. 0
12 00 12 12