User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
200
2900H EN 20071108Troubleshooting
DRYSTAR 5500/5503 REFERENCE MANUAL
Film input tray feed jams
The following screen indicates that a jam occurred in the feed section of the
input tray(s):
A message will inform you if either the upper or lower input tray is jammed.
To remove a jammed film in the input tray (e.g. upper input tray):
1 Start the procedure to stop printing as described in ‘Stopping the printing
process’ on page 59.
2 Wait while the printer is finishing printing any current jobs.
The printer is ready when the following message appears:
In the procedure, we will assume that the upper input tray is to be cleared. The
procedure for the lower input tray is identical.
<Modality name> 10:21:34 PRINTING
1 2
Blinking
Blinking