User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
216
2900H EN 20071108Troubleshooting
DRYSTAR 5500/5503 REFERENCE MANUAL
4 Press the Confirm key again to resume printing using a limited Maximum
Density.
Identification code error for upper/lower input tray
This identification code error appears in the following cases:
• you insert a new film pack with a encryption error in the Film
Identification tag,
• you have loaded a Mammo film pack or a Mammo film, whereas the
Mammo license is not activated.
Call your local service organization to resolve this problem. You can unlock
the tray to insert another film pack.
Identical identification code detected in upper/lower input tray
In case you have loaded a film pack with a non-unique Film Identification tag
(meaning that the current tag has been used with a previous film pack), the
following message is displayed:
Proceed as follows:
If the “Overrule RF-tag Reading” Setting is not activated, the following message will
be displayed:
In this case, press the Confirm key to initiate the loading procedure again or call
your local service organization to enable the “Overrule RF-tag Reading” Setting.