User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
35
2900H EN 20071108 Introducing the Drystar 5500
DRYSTAR 5500/5503 REFERENCE MANUAL
2 The printer is ready for operation:
• If, on the front panel display, the READY message is shown, the status
indicator LED is constant green.
• If, on the front panel display, the Print queue screen is shown, the status
indicator LED is green and blinking.
3 Make sure that the printer is loaded with appropriate consumables.
It takes 11 minutes before the Drystar 5500 can start printing. After 6 minutes the
READY message appears and from then on you can send print jobs to the printer,
but it will take another five minutes for the printer head to heat up. When you send
print jobs to the Drystar 5500 during this five minutes, the printer will use that
time to calculate the print job and the display will inform you that the printer is
warming up.
Refer to page 46 for detailed information on loading films.
If the job status holds a warning or error indication. Refer to ‘Troubleshooting
checklist’ on page 194 .
<Modality name> 10:21:34 PRINTING
1 2
<Modality name> 10:21:34 CALCULATING
<Modality name> 11:35:27 WAITING
<Modality name> 11:54:02 WAITING