User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
36
2900H EN 20071108Introducing the Drystar 5500
DRYSTAR 5500/5503 REFERENCE MANUAL
Cooling down the Drystar 5500
If owing to certain circumstances (e.g. extensive printing), the temperature
rises too much, the Drystar 5500 will cool down automatically. The cooling
down message will appaear on the display during the cooling down process.
Switching off the Drystar 5500
When you want to switch off the printer, it is recommended to follow the
procedure as described below, to make sure that any pending jobs are
correctly finished.
1 Make sure that the pending jobs are correctly finished. If necessary, follow the
procedure to stop printing. Refer to ‘Stopping the printing process’ on page 59.
2 Press the Power button to switch off the Drystar 5500.
In case the printer is ready, it shuts down immediately. Otherwise it can take up to
10 seconds to power down.