User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
69
2900H EN 20071108 Advanced operation (Key-operator mode)
DRYSTAR 5500/5503 REFERENCE MANUAL
Changing the configuration settings
A number of data and parameters settings of the printer can be viewed and
changed by using the ‘change settings’ function.
Each time the settings have been changed, the new configuration is automatically
stored on the hard disk of the printer. You will be asked to create a back-up floppy
with the new settings.
Change settings Page
General
‘Changing the date and time’ 72
‘Changing the language’ 73
‘Changing the sorter configuration’ 74
‘Changing the assignment modality - output tray’ 75
‘Changing the beep on empty tray settings’ 76
Input tray (Upper or Lower)
‘Changing the film view’ 77
Network (DICOM)
‘Changing the Printer AE-title (Called AE-title)’ 78
‘Changing the Hostname’ 79
‘Changing the Domain name’ 80
‘Changing the Printer IP-address’ 81
‘Changing the Netmask’ 83
‘Changing the Router IP-address’ 84
‘Removing a modality’ 86
‘Adding a modality’ 87