User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
84
2900H EN 20071108Advanced operation (Key-operator mode)
DRYSTAR 5500/5503 REFERENCE MANUAL
Example: If the Netmask is 250.760.560. 0, then the data entry should be as follows:
5 Press the Confirm key to store the data, or the Escape key to quit the procedure
without any changes.
Changing the Router IP-address
1 Perform steps 1 to 2 of the ‘Accessing the Change settings menu’ procedure on
page 70.
2 On the ‘Change setting’ screen, press the Down key three times, followed by the
Confirm key to select ‘Network Dicom’.
The ‘Network Dicom’ screen is displayed:
3 On the ‘Network-Dicom’ screen, press the Down key five times, followed by the
Confirm key to select ‘Router IP-address’.
The ‘Router IP-address’ screen is displayed:
If the Router IP-address has already been assigned, it will be shown on the display.
4 Enter the Router IP-address by means of the arrow keys. Refer to ‘Data entry’ on
page 33.
Note that blank spaces will not be filled in (see examples on the next page).
25 .76 . 56 .
e.g. 10.233. 92. 1