User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
86
2900H EN 20071108Advanced operation (Key-operator mode)
DRYSTAR 5500/5503 REFERENCE MANUAL
Removing a modality
1 Perform steps 1 to 2 of the ‘Accessing the Change settings menu’ procedure on
page 70.
2 On the ‘Change setting’ screen, press the Down key three times, followed by the
Confirm key to select ‘Network Dicom’.
The ‘Network Dicom’ screen is displayed:
3 On the ‘Network-Dicom’ screen, press the Down key six times, followed by the
Confirm key to select ‘Remove modality’.
The ‘Remove modality’ screen is displayed:
The modality names, entered during installation of the printer, are shown in the list. If
no names have been entered, the Called AE-titles are shown instead. In case there is
also a nickname (daily used name) defined during installation, the nickname is used.
4 Select the modality which you wish to remove by means of the arrow keys.
5 Press the Confirm key to remove the modality name from the list, or the Escape
key to quit the procedure without any changes.
7 Remove modality
8 Add modality
1 <Modality name>
2 <Modality name>
3 <Modality name>
4 <Modality name>
5 <Modality name>