User's Manual Part 2

67
2920B EN 20031206
Changing the film format
Using the following procedure you can overrule the film format which is
automatically read by means of the Film Identification tag on the film pack.
1 Perform steps 1 and 2 of the ‘Accessing the Change settings menu’
procedure on page 59.
2 On the Change settings menu, press the Down key, followed by the Confirm
key to select ‘Input tray’.
The ‘Input tray’ screen is displayed:
3 Press the Down key twice, followed by the Confirm key to select ‘Film format’.
The ‘Film format’ screen is displayed:
The film format read by the Film Identification tag is marked with a ‘*’.
" The message ‘OVERRULE to RF-tag’ is only visible if the film format,
specified by the Film Identification tag, has been overruled.
4 Press the up/down arrow keys to select the film format.
5 Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
" The overrule settings remain active until a new film pack is loaded.
This procedure is only to be used exceptionally when the Film
Identification tag info is incorrect.
CS
1 Film view
2 Film type
3 Film format
CS
1*14x17”
211x14”
OVERRULE to RF-tag
Flashing