Service manual

Section I: Imagesetter
Diagnostics 3-47
Edit File
Selecting Edit File allows a text file to be edited using the DOS editor without exit-
ing the AVDIAG program. When edit file is selected, a dialog box appears with
prompts for entering a filename to edit. Type in the desired filename and press
ENTER. Note that the entire path must be specified as shown in the following
example:
Filename?
cmd\imgfeed.cmd
The DOS editor starts and loads the file selected. If the filename is not known or
you wish to create a new file, press ENTER at the dialog box. The DOS editor starts
without loading a file.
Set Config Passwd
This menu selection changes the imagesetter password. The user is asked for the
original password before allowing a new password to be entered.
Toggle Comm. Display
Selecting this menu item enables or disables the monitoring of the APIS commands
to and from the AVDIAG program. This mode is usually used in program debug-
ging mode.
Feed/Error Disable
This menu selection allows the user to disable both film feeding and error report-
ing.
.
Set Real-Time Clock
Use this menu to Set Real-Time Clock. It first must be enabled in the “Engine Con-
figuration” menu. If the system supports Real Time Clock then only the last 30
errors will be displayed.
Below is an example of the dialog box to set the Date and Clock.
Menu Item Function
ERROR Disable Disables error reporting
FEED Disable Disables Feeds
BOTH Disable Disables both feed and error
reporting
BOTH Enable Enables both feed and error
reporting