Service manual

Section I: Imagesetter
Installation 1-3
If the customer is setting up the optional on-line processor (OLP)/buffer as
well, their physical specifications are:
Buffer
Width: 61" (154.94 cm)
Height: 54" (137.16 cm)
Depth: 15" (38.10 cm)
Weight: 200 lbs. (90.72 kg)
On-line Processor (OLP)
Width: 61" (154.94 cm)
Height: 54" (137.16 cm)
Length: 66" (167.64 cm) excluding receiver tray
98" ( cm) including receiver tray, roll mat.
120" ( cm) including recevier tray, sheet mat.
Weight: 937 lbs. dry (425.02 kg)
1136 lbs. wet (515.28 kg)
• Telephone Requirements
A modem connected to the system provides remote diagnostic capabilities.
If a modem is attached, a dedicated (or multiplexed) telephone line must
be provided. A voice phone line in close proximity to the system is also
highly recommended. The phone line connector must be an RJ11C type
connector.
• Film Processor Requirements
It is recommended that a customer producing color separations use a deep
tank film processor. An AGFA processor is preferred (i.e. RAPILINE 44 OLP
and P). The processor must be able to handle media widths of 36inches or
greater. If a new processor is to be installed, electrical requirements for the
processor must also be considered. Refer to the film processor's specifica-
tion sheet/manual for this information.
• Miscellaneous
Before installation, the customer should also consider the following:
• Doorways–must be at least 73" (185.42 cm) wide for the Avantra imag-
esetter to pass through.
• Elevator–physical inside dimensions and load capacity of the elevator
must be able to handle the transporting of the system to the desired
floor. The Avantra imagesetter dimensions and weight are listed in
Work Space above.