Service manual

Avantra 36/44 Service Manual

1-2 Installation

1.2 Removing the Imagesetter Top Cover

Before the bridge can be installed into the imagesetter, the top cover must be

removed.

Steps

Tools required: Screwdriver

1. At the rear of the imagesetter, remove the allen screws attaching the top

back panel. Refer to Figure 1-1.

2. Raise the top cover.

Figure 1-1 Rear of the imagesetter.

➀

–Top cover.

➁

–Hinge stop.

➂

–Hinge stop bolt.

➃

–Gas shock retaining bolt.

➄

–Top back panel allen screws.