Service manual

Section II: Bridge
Installation 1-11
Figure 1-10 Aligning the bridge using the guide blocks.
➀ –Guide block (one of two).
5. Also make certain that the bridge bearing blocks (top left and right) are
straight. If they are, secure to the lower casting by tightening the three (3)
allen screws. Refer to Figure 1-11.
Figure 1-11 Securing the bearing blocks.
➀ –Bearing block. ➁ –Sensor reflector. ➂ –Three allen screws. ➃ –Lower casting.
1
1 3
4
2