Service manual

Avantra 36/44 Service Manual

1-16 Installation

5. Make certain that the detent plate adjustment allen screws are loose on the

detent plate. Refer to Figure 1-17.

6. Screw the spring plungers in until the spring loaded ball centers within the

front V-groove of the detent plate. Refer to Figure 1-17. Make certain that

the detent just touches the ball.

Figure 1-17 Adjusting the detent plate.

➀–Detent plate. ➁–V-groove. ➂–Adjustment allen screws.

7. Back the screw out 1/2 turn.

8. Slide the detent plate forward and hold it in place.

This step preloads the spring plungers, which exerts a downward force

when the bridge is in the down position.

9. Tighten the detent plate adjustment allen screws.

10. Lift the bridge halfway so that the plunger ball centers in the detent plate.

11. Screw in the spring plunger one full turn.

12. Raise the bridge all the way to make certain that the plunger springs into

the back groove.

13. Lower the bridge to check that the plunger springs into the front groove.